This site requires cookies to work properly. Note that if you continue navigating our website, you indicate your consent to our use of cookies. More Information at the Data Protection Statement.

Spanish EnglishGerman



bintec ESW4000-52T

Manageable L2+ Switch with 52 ports


  • 48 Gigabit Ethernet ports
  • 4 SFP ports with up to 4Gbit/s uplink
  • 104 Gbit/s switch capacity
  • Extensive L2 feature set (QoS, Security, ...)
  • Energy efficient by 802.3az support
  • Manageable via Web, CLI, prepared for be.SDx
  • Available End of January 2019





bintec ESW4000-52T

The bintec ESW4000-52T is a powerful L2 switch for enterprise applications.


The bintec ESW4000-52T is a cost optimized version of the bintec ESW4000-52P without PoE support. The protocol 802.3az reduce the power consumption in case of use short ethernet cables by reducing the transmit level. Ports there not in use are switched off automatically to save energy. Additional to the 24 Gigabit Ethernet ports are four SFP port available to connect fiber cables via SFP transceiver.

Extensive L2 feature allow a efficient management. In example allow the IEEE 802.3ad Link Aggregation Control Protocol (LACP) a efficient loadblancing and fault tolerance.

The switch ESW4000-52T is manageable via a web interface or via a CLI interface. In addition is the switch prepared for the coming up bintec SD-WAN solution be.SDx.

Ethernet Ports
48x 10/100/1000BASE-T Ports with RJ45 socket; Auto-negotiation for port speed and duplex mode (Auto MDI/MDI-X)
SFP Ports
4x IEEE 802.3 100BASE-FX; IEEE 802.3z (1000BASE-SX/LX/LHX/ZX) transceiver; Transceiver threshold current/rx-power/temperature/tx-power/voltage/high-low alarm and warnings; DDM (Digital Diagnostic Monitoring)
Console port
RJ45 socket, serial interface via adaptor cable (R45<->DB9)
Spanning Tree Protocol
IEEE 802.1D Spanning Tree Protocol (STP); IEEE 802.1w Rapid Spanning Tree Protocol (RSTP); IEEE 802.1s Multiple Spanning Tree Protocol (MSTP); BPDU Guard; BPDU Filtering; Root Guard; BPDU Transparent; Loopback detection; Non loopback detection
VLAN
Supports 4K VLAN; Port-based VLAN; IEEE 802.1Q VLAN; GVRP (256 VLAN); IEEE 802.1v protocol-based VLAN; IP Subnet-based VLAN; MAC-based VLAN; Traffic Segmentation
L2 Virtual Private Network (Q-in-Q)
Selective Q-in-Q; VLAN Translation; L2 Protocol tunneling (xSTP, CDP, VTP&PVST+; LLDP); CDP/PVST+ Filtering
Link Aggregation
Static Trunk; IEEE 802.3ad Link Aggregation Control Protocol; Trunk groups 16 up to 8 GE ports per group; Load Balancing (SA+DA, SA, DA, SIP+DIP, SIP, DIP)
IGMP Snooping
IGMP v1/v2/v3 Snooping; IGMP Proxy Reporting; IGMP Filtering; IGMP Throttling; IGMP Immediate Leave; IGMP Querier; IGMP mrouter-forward-mode; IGMP Router-alert-option-check; IGMP Router-port-expire-time; IGMP tcn-flood; IGMP tcn-query-solicit
Multicast VLAN Registration (MVR)
Support 5 multicast VLANs Port mirroring. Multiple source ports to one destination port or one source port to one destination port.
Priority Queues
8 hardware queues per port
Traffic classification
IEEE 802.1p CoS; IP Precedence; DSCP
Traffic scheduling
Strict Priority; Weighted Round Robing; Strict+WRR
Diffserv
Ingress policy map (police rate, remark CoS); Egress policy map (police rate, remark CoS/DSCP)
Rate Limiting
Ingress and Egress per port base; Resolution 64 to 1000 Mbps
IPv4 static route
Supported
RIP support
RIP v1/v2
Traceroute
Traceroute/Traceroute6
IPv4/IPv6 dual protocol stack
Supported
IPv6 Address type stack
Unicast
IPv6 Neighbor Discovery
Duplicate address; Address resolution; Unreachable neighbor detection
IPv6 configuration
Stateless auto-configuration; Manual configuration
Other IPv6 features
Remote IPv6 ping; IPv6 Telnet; HTTP over IPv6; SNMP over IPv6; IPv6 Syslog; IPv6 TFTP; IPv6 MLD filtering and throttling; IPv6NM snooping; IPv6 source guard; DHCPv6 snooping; MVR6
IEEE 802.3ah
IEEE 802.3ah Link
IEEE 802.1ag
Cross check; Link trace; Loop back
ITU-T Y.1731
Performance and Throughput Management
User security
IEEE 802.1X port based and MAC based authentication; Dynamic VLAN assignment; Dynamic QoS assignment; MAC authentication; Web authentication; Voice VLAN; Guest VLAN
User security for ISP/MSO
L2/L3/L4 Access control list; MAC Access control list; IP Access control list (Source IP); IP extended Access control list; DHCP snooping; DHCP option 82; DHCP option 82 relay; IP source guard
Network security
IPv6 ACL; Port security; PPPoE IA; Dynamic ARP inspection; CPU guard; CPU/Memory threshold and alarm; DOS protection
Management Security
IEEE 802.1X port based and MAC based authentication; Dynamic VLAN assignment; Dynamic QoS assignment; MAC authentication; Web authentication; Voice VLAN; Guest VLAN
Switch management
Prepared for the bintec SD-WAN solution be.SDx; Web management; CLI via console port or Telnet; SNMP v1, v2c, v3
Configuration management
Configuration file up/download via TFTP/HTTP/FTP/SFTP; Multiple configuration file support
Firmware management
Firmware update via TFTP/HTTP/FTP/SFTP; Dual images; Firmware auto update
Monitoring
sFlow v4, v5 support; Cable diagnostic; Event/Error log; Syslog; RMON (groups 1,2,3,9)
Other management features
BOOTP; DHCP client for IP address assignment; DHCP dynamic provision option 66,67; SNTP/NTP; DNS client; SMTP; LLDP (802.1ab)
Green Ethernet
Energy-Efficient Ethernet according 802.3az
Cable lenght detection
Reduce the power at short Ethernet cables
No-Link detection
Switches off unused ports automatically to save energy.
Performance values
Switch Capacity 104 Gbps; Forward rate 77,4 Mbps; MAC Address table size 16k; Jumbo Frames 12kB; Flash Memory 32MB / DRAM 256MB; Auto-MDI/MDIX
Power Supply
Integrated power supply 100-240 VAC, 50-60Hz with cold device plug at the rear panel; Maximum power consumption 40 Watt
Dimension / Weight
Dimension 44x22x4,4 cm (W x D x H); Weight appr. 2,5 kg
Acoustics
Fanless design
Environmental
Operation 0°C to 45°C; Storage -40°C to 70°C; Humidity in operation and storage 10% to 90% (non-condensing)
Approvals
EN60950-1; EN61000-3-2; EN61000-3-3; EN61000-4-2; EN61000-4-3; EN61000-4-4; EN61000-4-5; EN61000-4-6; EN61000-4-8; EN61000-4-11; EN55032; EN55024
Content of delivery
Power supply cable with EU-plug, 19" mounting kit with 2 brackets and 8 screws; 4 foot pads; Adaptor cable RJ45<->DB9 for console port; Quick install guide

bintec ESW4000-52T Part number: 5510000475

Part number 5530000190  bintec SFP-LC-TX/LX/LH

Part number 5530000189  bintec SFP-LC-SX



Request Info
X